N30P meter is destined to measure: AC voltage, AC current, active, reactive and apparent power, cos φ, tg φ, φ, frequency, active, reactive and apparent energy, 15 min. active power, 10 min. voltage, 10 sec. frequency in single-phase power network.
Input:
- Current: 0…1 or 0…5A
- Voltage: 0…100V or 0…400V
Output:
- Relay (4), analog (1), energy pulse (1), digital RS485/MODBUS (1)
- 3-colour display – red, green and orange programmable in three intervals of the measured value
- 14mm digit hight
- Highlighted measuring units
- 4 alarm outputs with signalling by LED diodes, operating in 6 different modes
- Conversion of any measured value into a 0/4…20mA or 0…10V analog signal
- Storage of minimal and maximal values for all measured quantities
- Meter programming from the keyboard or through the RS485 interface by means of free eCon software
Parameters can be reprogrammed are as follows:
- Display colour, individually in three intervals
- Thresholds of displayed overflows
- Display precision of the result (decimal point)
- Highlight of the unit
- Average time of the measurement
- Recounting of indications (individual characteristic)
- Power supply: 85…253V AC/DC or 20…40V AC/DC
- Protection level from frontal side: IP65
- External dimensions: 96 x 48 x 64 mm.
Reviews
There are no reviews yet.